Refer to the exhibit. Based upon the configuration, you need to understand why the policy routi match counts are not increasing. Which would be the first logical step to take?（） -题库考试答案搜索网

Refer to the exhibit. Based upon the configuration, you need to understand why the policy routi match counts are not increasing. Which would be the first logical step to take?（）

单选题

2022-01-05 23:26

A、Confirm if there are other problematic route - map statements that precede divert.
B、Check the access list for log hits.
C、Check the routing table for 212.50.185.126.
D、Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)

查看答案

正确答案

试题解析

标签： CCNP(642-902)

感兴趣题目

Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）

Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?（）

Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?（）

Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?（）

Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）

The network layer provides services to the transport layer. It can be based on either virtual circuits or datagrams. In both cases, its main job is （）packets from the source to the destination.

Refer to the exhibit. How will interface FastEthernnet0/1 respond when an 802.1x-enabled client connects to the port？（）

Refer to the exhibit.Which is the most efficient summarization that R1 can use to advertise its networks toR2？（）

Refer to exhibits 1 and 2. In exhibit 1， all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2， the network management team reported that there is no utilization on the WAN link B. To solve this problem， you decide to change the logical topology of your LAN， but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design， automatic redundancy， and load balancing. Which one of these actions would be the best choice？（）

Refer to the exhibit. AS 65500 is not advertising the prefix 192.168.12.0/22 to its provider. AS 65500 is running OSPF as its IGP. Whi ch of the following additions to the configuration is most likely to solve the problem?（）