A new switch is being installed and you have been assigned the task of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches. Which of the following must you do to accomplish this?（） -题库考试答案搜索网

A new switch is being installed and you have been assigned the task of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches.
Which of the following must you do to accomplish this?（）

多选题

2022-01-09 16:26

A、You must set each end of the trunk line to IEEE 802.1e encapsulation.
B、You must set the same VTP management domain name on both switches.
C、You must set all ports on the two switches as access ports.
D、You must configure one of the switches as a VTP server.
E、You must use a rollover cable to connect the two switches.

查看答案

正确答案

B| D

试题解析

标签： CCNA(640-801)

感兴趣题目

The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch.What must be done to ensure that this new switch becomes the root bridge on the network?（）

You are installing Windows 2000 server on Windows NT using an unattended installation. You find out the SCSI adapter is not supported by Microsoft HCL. You find out from the manufacturer that a new driver is available for installing on Windows 2000. How should you enter this information in the unattended installation?

You install Windows Vista on a new computer by using the retail installation media.
You install a new hardware device. You are not prompted for any drivers and the installation completes successfully.
You discover that an updated driver is available for the hardware device.
You need to install the updated driver.
What should you do?（）

A new Catalyst switch is connected to an existing switch using a crossover cable. As a result of this, what would the switch port link lights display?（）

A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffiC.What is the effect of adding switch ports to a new VLAN on the switch?（）

Which of the listed devices could be used as a ring groove tool during preparation for the installation of new rings?（）

A new switch is installed in the Ezonexam network. This switch is to be configured so that VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.

In a diesel engine, when installing new piston rings it is important to check（） Ⅰ.ring gap clearance Ⅱ.side clearance

New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）

Before installing a new device， a technician checks to make sure the device is on the HCL. Which of the following is the advantage of having an HCL device？（）

After completing an installation of new software， a system administrator notices the system is slow. To troubleshoot the performance， which single AIX command could be used to provide a real-time display of CPU， memory and disk utilization（）

Write a memo in about 50 words.
You are a department manager. A new copying machine has been installed in your department. Write a memo to tell your staff members to be careful in using the newly-installed photocopier. Your instructions should include the following particulars:
·Ask them not to use it for too long at a time. ·Ask them to switch off the machine after use.
·Encourage them to offer suggestions for the care of the machine.