If the pump for a hydraulic anchor windlass is over heating, the cause may be （）. -题库考试答案搜索网

If the pump for a hydraulic anchor windlass is over heating, the cause may be （）.

单选题

2022-06-28 14:47

A、increased pump speed
B、excessive pump discharge pressure
C、too low of a tilting box angle
D、low pump speed

查看答案

正确答案

B

试题解析

标签：船舶辅助机械

感兴趣题目

If a centrifugal pump vibrates and is noisy when operating, the cause could be （）.

If the capacity of a centrifugal pump decreases gradually over a long period of time, you should replace the （）.

Through a （） pump, the liquid is transferred from the suction to the discharge by the mechanical variation of the volume of a chamber or chambers.

It will be a relief over the death of a friend or a relative if the friend or relative dies from ______.

If a centrifugal pump were continually operated with the discharge valve closed, the （）.

If a centrifugal bilge pump were continually operated with the discharge valve closed the （）.

（）uses one or two high pressure pumps for all the cylinders with one more standby, while（）have a separate high-pressure pump for each cylinder.

When installed for bilge pumping or ballast duty, centrifugal pumps require a （） to remove air from the suction pipe.

The best method of determining if a vessel is dragging anchor is to note（）.

If you were operating a centrifugal water service pump with worn wearing rings, the （）.

If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.

If the pump for a hydraulic anchor windlass is over heating, the cause may be （）.

相关题目: A centrifugal pump may fail to deliver water when first started if the （）.; It is important with all hydraulic systems to ensure that interlocking arrangements provided for pump or motor control levers are （） before the pump driving motor can be started.; Fuel injection uses the jet pump system and a Woodward type hydraulic （） is used to control engine speed.; A measurement device for inspecting anchor chain is the（）.; A common trouble with the fuel pump plunger or fuel valve spindle is （）.; A common trouble with the fuel pump plungers or fuel valve spindle is （）.; Which characteristic or condition will have the greatest effect on increasing a hydraulic oils viscosity?（）; If a bilge pump failed to build up discharge pressure, you should check for （）.; If you install a new hydraulic hose in a hydraulic system, the hose must be long enough to allow for contraction to prevent; If the compensating needle valve of a hydraulic governor is opened more than necessary the governor will （）; If one hydraulic pump of an electro-hydraulic steering unit falls, the vessels steering can be initially and best maintained by using the （）.; The discharge rate or capacity of a centrifugal pump will vary directly as the （）.; The delivery rate of an axial-piston hydraulic pump is controlled by varying the position of the （）.; After installing a new hydraulic pump in a system, what special attention should be given to the hydraulic system?（）; After installing a new hydraulic pump in a system, what special attention should be given to the hydraulic system?; Sluggish response or action of the hydraulic actuators may be a result of （）.; On a ship，a fire pump may be used for other purposes if（）.; A fire pump may be used for other purposes if（）.; A fire pump may be used for other purposes if（）.; The rotating unit of a spilt windlass consists of a（） with shaped snugs to grip the anchor cablea mooring drum for paying out or letting go of mooring wires and warp end for warping duties.

广告位招租WX:84302438

题库考试答案搜索网

免费的网站请分享给朋友吧