How can a Ezonexam administrator determine if a router has been configured when it is first powered up? -题库考试答案搜索网

How can a Ezonexam administrator determine if a router has been configured when it is first powered up?

单选题

2022-06-28 21:29

A、A configured router prompts for a password
B、A configured router goes to the privileged mode prompt
C、An un configured router goes into the setup dialog
D、An un configured router goes to the enable mode prompt

查看答案

正确答案

试题解析

解析：Explanation:If a non-configured router is started, then it goes into setup mode and ask for the minimum configuration parameters (hostname, IP address to interfaces, enable password, etc). If the router is already configured it boots by implementing the saved startup-config.

标签：

感兴趣题目

A condition where two currents meet at the downstream end of a middle bar can be determined by a（）.

A user has written a script that is not running correctly and asks an administrator for help.
Without adding anything to the script, how can the administrator determine the cause of the problem?（）

A user has written a script that is not running correctly and asks an administrator for help. Without adding anything to the script， how can the administrator determine the cause of the problem？（）

If you（）a magnet-needle, its two ends can point North and South, and so it can be used to determine directions.

A student can rent a locker in the library if he _____.

How can a SART’s effective range be maximized? （）

Why might the Ezonexam network administrator set the configuration register to 0x2142 on a 2600 series Cisco router?

How can a Ezonexam administrator determine if a router has been configured when it is first powered up?

What will a new Ezonexam router do during startup if a configuration file is not located in NVRAM?

What determines if a vessel is restricted in her ability to maneuver?（）.

John buys a cake at a bakery and a hammer at a hard-ware store. If there are five hardware stores and three bakeries, in how many different combinations of stores can he purchase the cake and the hammer?

The network administrator is in a campus building distant from Building B. WANRouter is hosting a newly installed WAN link on interface S0/0. The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface. How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner（）。