首页/ 题库 / [单选题]Which OSPF router wi的答案

Which OSPF router will advertise a Type 2 network LSA for a broadcast network segment?（）

单选题
2022-06-28 21:30
A、A
B、B
C、C
D、D
查看答案
正确答案
A
试题解析
标签： CMS专题
感兴趣题目
Which type of cable should be used to make a connection between the Fa0/0 port on a router and the Fa0/0 port switch?（）
Which OSPF area type allows for the flooding of a Type 7 LSA?（）
Which router is doing LSA type 7 to type 5 translation，and why？（）
Which is true about OSPF router-id?（）
A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。
What is the OSPF default frequency,in seconds,at which a cisco router sends hello packets on a multi-access network?（）
By default, to which peers will a BGP router advertise routes learned from IBGP peers?（）
Router R1 needs to be configured to advertise a specific network. Which of the followingcommands would you use if you wanted to advertise the subnet 154.2.1.0 255.255.255.0 to the EBGP neighbors on your subnet？（）
Which OSPF router will advertise a Type 2 network LSA for a broadcast network segment?（）
What is the purpose of the OSPF router ID in a OR/BOR election?（）
Which two of the following actions must an OSPF NSF-capable router execute after a supervisor engine switchover?（） (Choose two.)
相关题目
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
A new network has been configured using OSPF as the routing protocol. With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?（）
Which of the following is not a valid setting for the PROGRAM_TYPE parameter in a program object or the JOB_TYPE parameter in a job object?（）
The maximum number of routers per OSPF area typically depends on which three factors?（）
Which of the following data structures exist on a router for the OSPF routing protocol？（）
Which commands are required to properly configure a router to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?（）
Which command will display all the EIGRP feasible successor routes known to a router?（）
Which parameter or parameters are used to calculate OSPF cost in cisco routers?（）
Which parameter or parameters are used to calculate OSPF cost in cisco routers？（）
Under which circumstance will a branch ISR router contain interface vlan configurations?（）

Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.
Which combinations accurately describe the interface under which a feature will be configured?（）
You need to configure a default route on a Ezonexam router. Which command will configure a default route on a router?
Which command will configure a default route on a router?（）
A semisubmersible which will not remain upright and will assume a list either to port or starboard is likely to have（）.
Which of the following can either directly or indirec tly identify all the interfaces for which both 1) OSPF has been enabled and 2) OSPF is not passive?（）
When learning a new route, if a LSA received is not found in the topological database, what will an internal OSPF router do?（）
When an OSPF design is planned, which implementation can help a router not have memory resource issues?（）

The following was issues on router TestKingA:
TestKingA #show ip ospf neighbor
Neigbor ID PRI State Dead Time Address Interface
192.168.1.2 1 Full/- 00:00:37 192.168.1.2 Serial1
Which type of OSPF network will provide the output shown in the graphic?（）
A network administrator needs to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface for this connection?（）
When verifying OSPF virtual link problems, which is an important item to check on the two transit OSPF routers?（）
广告位招租WX:84302438
题库考试答案搜索网

免费的网站请分享给朋友吧

题库考试答案搜索网 2022 ©

关于我们网站声明合作共赢