首页/ 题库 / [单选题]Refer to exhibits 1 的答案

Refer to exhibits 1 and 2. In exhibit 1， all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2， the network management team reported that there is no utilization on the WAN link B. To solve this problem， you decide to change the logical topology of your LAN， but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design， automatic redundancy， and load balancing. Which one of these actions would be the best choice？ （）

单选题
2022-10-01 13:55
A、 Use MHSRP， with three users using router A as the default gateway and three users using router B as the default gateway.
B、 Keep HSRP and activate PBR to redirect half of the traffic to the other WAN link.
C、 Use the backup interface on the WAN link B to provide load balancing for all users.
D、 Use GLBP instead， because it provides you with up to three MAC addresses for the same default gateway virtual IP address.
E、 Use GLBP instead， because it provides you with up to four MAC addresses for the same default gateway virtual IP address.
查看答案
正确答案
E
试题解析
标签： CMS专题
感兴趣题目
Refer to the exhibit. EIGRP had converged in AS 1 when the link between router R1 and R2 went down. The console on router R2 generated the following messages: *Mar 20 12:12:06: %DUAL - 5NBRCHANG E: IP - EIGRP 1: Neighbor 10.1.4.3 (Serial0) is down: stuck in active *Mar 20 12:15:23: %DUAL -3- SIA: Route 10.1.1.0/24 stuck - in - active state in IP - EIGRP 1. Cleaning up The network administrator issued the show ip eigrp topology active command on R2 to check the status of the EIGRP network. Which statement best describes the reason for the error messages?（）
Practice 2　　● Recently your company is planning to bid for hosting an exhibition and now the manager of your company has asked you to write a letter to the organizing committee to introduce your company to them.　　● Write a letter to introduce the details about your company.　　● introducing the department structure and service,　　● introducing previous exhibitions you have hosted,　　● expressing your confidence in the success if you are permitted to host it.
Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?（）
Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?（）
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）
Refer to the exhibit.  How will interface FastEthernnet0/1 respond when an 802.1x-enabled client  connects to the port？  （）
Click the Exhibit button. A customer has several interconnected core rings (see exhibit). They want to create several irtual rings?utilizing their OC-192 backbone (nodes 1,2,3,4). What should you recommend?（）
Refer to the exhibit. In a redundant hub - and - spoke deployment using EIGRP, what feature can be used to ensure that routers C through F are not used as transit routers for data traveling from router B to network 10.1.1.0? Select the best response.（）
To examine the Exhibit, press the Exhibit button. Using the information provided in the exhibit, which of the following options indicates the date and time that the file system ran out of room?（）
Refer to exhibits 1 and 2. In exhibit 1， all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2， the network management team reported that there is no utilization on the WAN link B. To solve this problem， you decide to change the logical topology of your LAN， but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design， automatic redundancy， and load balancing. Which one of these actions would be the best choice？ （）
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command，  which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
相关题目
A vessel towing astern in an operation which severely restricts the towing vessel and her tow in their ability to change course shall，when making way，exhibit（）.
In telex abbreviations，CFM and INFM refer to（）and（）respectively.
Refer to the exhibit.What is the effect of the configuration that is shown?（）
Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?（）
Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured,what could be the cause of this problem?（）
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）
Refer to the exhibit. Which rule does the DHCP server use when there is an IP address conflict?（）

Refer to the exhibit.How many broadcast domains exist in theexhibited topology？（）

Refer to the exhibit. In a redundant hub - and - spoke deployment using EIGRP, what feature can be used to ensure that routers C through F are not used as transit routers for data traveling from router B to network 10.1.1.0? Select the best response.（）

Refer to the exhibit. OSPF is running throughout the network. You want to minimize the propagation of LSAs into and out of A rea 1. Which OSPF feature would best achieve this goal? （）
In case of your steering gear failed，（）should be exhibited in shapes or lights.
In case of your steering gear failed,（）should be exhibited in shapes or lights.

Click the Exhibit button. Which statement is true about the classes and interfaces in the exhibit?（）

Click the Exhibit button and examine the data in the EMPLOYEES and DEPARTMENTS tables.
You want to retrieve all employees, whether or not they have matching departments in the departments table. Which query would you use?（）

Refer to the exhibit. This shows the NetFlow statistics for a router. You are analyzing the traffic pattern and you are interested in the percentage of packets between 32 and 64 bytes in size and the number of flows in progress. Which of these identifies both numbers correctly?（）

Refer to the exhibits. You are verifying your OSPF implementation, and it does not seem to be functioning properly. What can you conclude from the exhibit and the show running - configuration command output? （）
Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）
Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?（）
A vessel constrained by her draught may，in addition to the lights prescribed for power-driven vessels in Rule 23，exhibit where they can best be seen（）or a cylinder.
Refer to the exhibit. The switchport output in Figure 1 displays the default settings of interface  FastEthernet 0/13 on switch SW1. Figure 2 displays the desired interface settings.  Which command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2？ （）
广告位招租WX:84302438
题库考试答案搜索网

免费的网站请分享给朋友吧

题库考试答案搜索网 2022 ©

关于我们网站声明合作共赢