（） are individuals and organizations that are actively involved in the project, or whose interests may be affected as a result of project execution or project completion.

Router R1 learns two routes with BGP for prefix 200.1.0.0/16. Comparing the two routes, route 1 has a longer AS_Path Length, bigger MED, bigger Weight, and smaller Loca l PreferencE.
Which of the following is true about Router R1's choice of best path for this prefix?（）

Consider the events_% tables in performance Schema.
Which two methods will clear or reset the collected events in the tables?（）

英译中：Enterprise resource planning(ERP)

Routers R1， R2， and R3 are configured in a hub and spoke frame relay environment， with router R1 as the hub. You have configured Router R1， Router R2， and Router R3 to run EIGRP over the frame relay connections. No sub-interfaces are used. You have configured a single IP subnet on all the Frame Relay interfaces. Router R1 can reach both router R2 and R3， but R2 and R3 can not reach each other. What is the probable cause of this problem？

Router R1 has working interfaces S0/0, S0/1, and S0/2, with IP address/prefix combinations of 10.10.10.1/24, 10.10.11.2/24, and 10.10.12.3/22. R1's configuration includes the command s router eigrp 9 and network 10.0.0.0. The show ip eigrp interfaces command lists S0/0 and S0/1 in the command output, but not S0/2.
Which answer gives the reason for the omission？（）

Router R1 sits  at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise.
Which of the following is most likely to be useful on the branch router?（）

Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.
Which combinations accurately describe the interface under which a feature will be configured?（）

Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, and into the core of an Enterprise network. The branch also allows local hosts to communicate directly with public sites in th e Internet over this same DSL connection.
Which of the following answers defines how the branch NAT config avoids performing NAT for the Enterprise directed traffic but does perform NAT for the Internet - directed traffic?（）

Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.
Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）

Router R1 lists 4 routes for subnet 10.1.1.0/24 in the output of the show ip eigrp topology all - links command. The variance 200 command is configured, but no other related commands are configured. Which of the following rules are true regarding R1's decision of what r outes to add to the IP routing table?
Note that RD refers to reported distance and FD to feasible distanc E.（）

A company uses Routers R1 and R2 to connect to ISP1 and ISP2, respectively, with Routers I1 and I2 used at th e ISPs. R1 peers with I1 and R2; R2 peers with I2 and R1. R1 and R2 do not share a common subnet, relying on other routers internal to the Enterprise for IP connectivity between the two routers.
Which of the following could be used to prevent potential routing loops in this design?（）